Outrigging Beam: Use the only single wooden piece and create 2 notches, sloped, as follows:ĭiagram 10: outrigging beam measurements.Ĭrossing Beams: Use the second set of 2 pieces of wood, creating 2 x 9″ notches, angles, tilting inwards in the direction of the axle. Trough: Use the molding, and staple each piece of Velcro at each end, leaving half the Velcro pieces extending beyond the ends, lengthwise. Follow the diagrams below to make the necessary cuts and measurements:ĭiagram 5: the long beam cuts as they should appear. Long Beam: Use the third set of 2 pieces of wood for this. Create 2 using the remaining first 4 pieces of wood. Or, see the following diagrams:ĭrawing 3: examples of leg 1, both sides.ĭiagram 4: measurements for cutting and angles for corner leg 1.Ĭorner Leg 2: Copy the procedures for corner leg 1, creating a mirror image. Mark 1 line, ¾ in away to connect those marks. Mark a measurement of 64.2, ¾ in from edges. This is only one leg, but cuts are made on both sides. Make two of these only.ĭiagram 1: adapted version of measurements for main beam.Ĭorner Leg: Use one of the first 4 wooden pieces. The first is located 1 in from the thickest end and the second is 10 in from that hole, heading towards the thinnest end. Drill two holes with the 3/8 in bit, perpendicular to the beam to carry the axles. Main Beam: Create a taper measuring 13.5 in from end 1 to 0.25 in at center, ending with a 0.5 in at other end. Electric drill, 3/8 in bit, 1/16 in bitĮach section is given a name, according to the original names designated to each piece historically. The final lengths of the ½ in x ¾ in pieces should equal 30 ft 3.5 in.Ĭut the board into ½ in pieces as follows:
0 Comments
Leave a Reply. |